LS Swap Transmission Options: 4L60E, 4L80E, 6L80 & T56

Sun West Transmissions — Glendale, AZ. Choosing the transmission is one of the biggest decisions in an LS swap. It shapes what the project costs, how the vehicle drives, whether you need a computer to run it and how much power it will hold. Here is how the most common LS swap transmission options compare.

Decide These Things First

The Common Choices Compared

TransmissionTypeStrengthsPlan for
4L60E familyFour-speed automatic, electronicCompact, light, plentiful, overdriveLight-duty in stock form; needs computer control; often needs upgrades for more power
4L80EFour-speed automatic, electronicVery strong; suited to towing and high powerHeavier and longer than a 4L60E; needs computer control; may need tunnel or crossmember work
6L80Six-speed automatic, electronicSix gears with two overdrives; stronger than a stock 4L60EIts built-in control module must be programmed to work with the engine computer
T56, TR-6060 or MagnumSix-speed manualThree pedals, two overdrives, strongClutch, flywheel, hydraulic release, shifter location, crossmember and driveshaft
TH350, TH400, 700R4Older GM automaticsTH350 and TH400 need no computer; the 700R4 adds overdriveConverter spacing on an LS; the 700R4 needs a correctly set TV cable

Size and gearing matter more than many people expect. A 4L80E is noticeably larger and heavier than a 4L60E, and a manual swap adds a pedal assembly and clutch hydraulics to the list. Overdrive ratios also change how a given rear axle ratio feels on the freeway. Measure the tunnel and crossmember area, and think through the gearing, before you buy a transmission.

Electronics: The Part Many Swaps Underestimate

The 4L60E, 4L80E and 6L80 are computer controlled. Shift points, line pressure and converter lockup all come from software. In a factory truck, the engine computer or a separate transmission module handles that job. In a swap, the computer and harness you choose must support the transmission, or you need a standalone transmission controller. The 6L80 adds a step, because its control module lives inside the transmission and has to be programmed to match the engine computer.

Getting this right affects both how the vehicle drives and how long the transmission lasts. Low line pressure or the wrong lockup settings can wear clutches quickly. Our TCM programming page explains what calibration involves on electronic units.

Older Automatics Behind an LS

The TH350, TH400 and early 700R4 predate the LS. They can be adapted, but the LS crankshaft flange sits about 0.400 inch further back than on older small-blocks, so the torque converter needs a crank spacer or a pilot adapter to engage at the correct depth, and converter bolt patterns may differ. The 700R4 also relies on a throttle-valve (TV) cable to set line pressure. If that cable is not set up correctly for the new throttle linkage, a 700R4 can burn up in short order.

Supporting Parts That Drive LS Swap Cost

Rebuild the Transmission Before It Goes In

A swap is the best time to deal with transmission wear, because the unit is already out. A used 4L60E or 4L80E from a salvage truck comes with unknown miles and heat history. Rebuilding it before installation, with upgraded parts if the power level calls for them, avoids pulling it twice. See our 4L60E rebuild, 4L80E rebuild and 6L80E rebuild pages, and our transmission upgrades for higher-power builds.

Talk to Sun West About Your Project

Sun West rebuilds the transmissions on this page, including the 4L60E, 4L80E, 6L80 and T56, provides TCM programming for electronic units and installs transmission coolers. Every swap is different, so if you are planning one, call us and talk through your project. We will tell you honestly what we can help with and what to plan for.

Transmission Rebuild Prices

Current Sun West prices for transmission rebuilds and upgrades are on our price pages:

Or call (623) 473-9800 for a free quote.

LS Swap Transmission FAQ

What is the best transmission for an LS swap?

It depends on the build. A 4L60E suits lighter, budget-minded swaps, a 4L80E suits high power and towing, a 6L80 gives modern gearing, and a T56-type six-speed is the choice for a manual.

Do I need a computer to run a 4L60E or 4L80E?

Yes. Both are electronically controlled, so they need an engine computer that supports them or a standalone transmission controller.

Can I bolt a TH350 or TH400 to an LS?

Yes, with the right crank spacer or adapter and attention to the converter. It is a common way to keep a swap simple.

What drives LS swap cost the most?

The transmission and its condition, the controller and wiring, the converter, cooling, the driveshaft and mounts, and any fabrication the vehicle needs.

Planning an LS Swap?

Sun West Transmissions
6116 W Northern Ave, Glendale, AZ 85301
Monday–Friday 7:30 am–5:30 pm · Saturday 8:00 am–4:00 pm
Phone: (623) 473-9800

Call to talk through the transmission side of your project. Our 3-year / 40,000-mile warranty covers qualifying rebuilds and replacements on non-commercial, non-modified vehicles, so ask about coverage for a swapped vehicle before work begins. Financing is available.